Rowans piston packing Rings and Spring

Rowans piston packing Rings and Spring

Creative Commons LicenseThis image is released under a CC BY-NC-SA 4.0 Licence

License this image for commercial use at Science and Society Picture Library

License

Rowans piston packing Rings and Spring
Science Museum Group
© The Board of Trustees of the Science Museum

Rowans piston packing Rings and Spring

In this packing the radial pressure expanding rings, and that securing the tightness of the rings against the sides of the recess in the piston, are obtained by independent springs. Two rings cut and fitted with the usual joint cover piece are employed, the radial expansion being secured by a short and flattened helical spring acting between two abutments provided inside the rings on each side of the cut. The longitudinal pressure, forcing the rings tightly against the sides of the piston recess, is supplied by inserting between the two rings a wave spring," formed by bending a flat bar of steel into a circle and then corrugating it. On screwing down the piston junk ring, these corrugations, or waves, are flattened to the extent necessary to give the requisite pressure. It is stated that a radial pressure of about 0.8 lb. per sq. in. is sufficient to prevent steam passing between the ring and the cylinder, but that a high longitudinal pressure is required to maintain the rings tight against their recess, depending upon the piston speed and the steam pressure.

Details

Category:
Motive Power
Object Number:
1891-106
type:
packing ring
credit:
Hind, J.